EXAMPLES
1. To list the instant recovery–enabled sessions (ZDB to disk or ZDB to disk + tape)
created using the backup specification "Backup1", run:
omnidbvss –list session –barlist Backup1
2. To get information about the backup components of all backup sessions created
before February 1st, 2009, and to save information about the backup
components and writer metadata to the directory "C:\metadata", run:
omnidbvss –get session_persistent -all older_than
2009/02/01 –save_metadata C:\metadata
Note that the specified directory must exist before you run the command.
3. To remove the reference information about the sessions "2009/02/11–1" and
"2009/02/11–2" from the VSSDB and to remove the associated replicas from
the disk array, run:
omnidbvss -remove session 2009/02/11-1 2009/02/11-2
4. To mount the target volumes from the session "2009/02/15–1" in the directory
"C:\mnt\", present them on the client system "backupsys", and to leave the
volumes mounted in read/write mode, run:
omnidbvss -enable session 2009/02/15-1 –backhost backupsys
-mnttarget C:\mnt —readwrite
Note that a new directory with the session ID is created and that the target
volumes are mounted in the directory "C:\mnt\2009–02–15–1".
SEE ALSO
omnidb(1M), omnidbcheck(1M), omnidbinit(1M), omnidbrestore(1M), omnidbsmis(1),
omnidbupgrade(1M), omnidbutil(1M), omnidbva(1), omnidbxp(1)
130
To Next Page
Loading...
