HP Data Protector A.06.11 - Omnimigrate.pl

omnimigrate.pl
helps you migrate your existing Cell Manager from a PA-RISC architecture based
HP-UX 11.x system to an HP-UX 11.23 system for the Intel Itanium 2 (IA-64)
architecture
nl
(this command is available on the Data Protector Cell Manager)
omnimigrate.pl
SYNOPSIS
omnimigrate.pl -help
omnimigrate.pl -prepare_clients New_CM_ClientName
omnimigrate.pl -configure
omnimigrate.pl [-configure_clients] [-configure_idb] [-config-
ure_cm]
DESCRIPTION
omnimigrate.pl helps you migrate your existing Cell Manager from a PA-RISC
architecture based HP-UX 11.x system to an HP-UX 11.23 system for the Intel Itanium
2 (IA-64) architecture.
First, you need to run omnimigrate.pl on the old Cell Manager and back up the
IDB. Then install Disk Agent to the HP-UX 11.23 system (your new Cell Manager)
and restore your IDB to the new Cell Manager. Uninstall the Disk Agent from the new
Cell Manager and install Data Protector A.06.11 Cell Manager. Finally run the
omnimigrate.pl command again on the new Cell Manager.
OPTIONS
-help
Displays the usage synopsis for the omnimigrate.pl command.
-prepare_clients New_CM_ClientName
Adds the new Cell Manager's client name to the list of trusted hosts on secured
clients. Secured clients accept requests on the Data Protector port (by default
5555) only from trusted hosts.
This option should be used only on the old Cell Manager.
-configure_clients
Command line interface reference 361