omniusers
adds or removes Data Protector users to or from an existing Data Protector user group,
or lists the configured Data Protector users. It enables you to use all GUI functionality
on a Cell Manager platform on which the GUI is not supported, using a GUI installed
on another system.
nl
(this command is available on systems with the Data Protector User Interface
component installed)
omniusers
SYNOPSIS
omniusers -version | -help
omniusers -add -type {U | W} -usergroup DPUserGroup -name UserName
-group GroupOrDomainName -client ClientName [-desc Description]
omniusers -remove -name UserName -group GroupOrDomainName -client
ClientName
omniusers -list
DESCRIPTION
The command adds, removes or lists the configured Data Protector users on the Cell
Manager where it is run. It does not create or remove user groups.
Use the command to create a remote Data Protector user on those Cell Manager
platforms on which Data Protector GUI is not supported. You can then use the created
user account to start the Data Protector GUI on another system with the Data Protector
GUI installed, and connect to the Cell Manager.
OPTIONS
-version
Displays the version of the omniusers command.
-help
Displays the usage synopsis for the omniusers command.
-add
Adds a user to the specified Data Protector user group.
-remove
Removes a user from its Data Protector user group.
-name UserName
Command line interface reference 271
To Next Page
Loading...
Need help?
General