omnimver
verifies data on a medium
nl
(this command is available on systems with the Data Protector User Interface
component installed)
omnimver
SYNOPSIS
omnimver -version | -help
omnimver -device BackupDevice [-slot SlotID [Side]] [-eject]
DESCRIPTION
The omnimver command is used to verify the contents of a Data Protector backup
medium. It reads the data and verifies that data is written in Data Protector format.
If the -crc option was used to backup the data it also checks the CRC for each
block.
OPTIONS
-version
Displays the version of the omnimver command
-help
Displays an extended usage synopsis for the omnimver command
-device BackupDevice
Specifies the backup device where medium is located.
-slot SlotID [Side]
Specifies the SlotID of the Exchanger backup device where the medium is
mounted. This option is only valid for this backup device type. To specify the
side of the platter in this slot, use the additional Side parameter. Slot Side must
be specified for MO devices.
-eject
Ejects the medium from the drive after the verification.
EXAMPLES
To verify slot 32 of backup device "Spectra60", run:
Command line interface reference 169
To Next Page
Loading...
Need help?
General