EXAMPLES
1. To start an objectconsolidation session that consolidates the WinFS object versions
for "OBJECT1" on the host "system1.company.com" to the point in time defined
with the session ID "2008/09/06-1", using the device "LTO3" as the source
device and the file library "FILEDEV1" as the consolidation device, and writes
the consolidated objects to the device "LTO4", use:
omniobjconsolidate -winfs system1.company.com:/C 'OBJECT1'
-session 2008/09/06-1 -sourcedevice 'LTO3'
-consolidationdevice 'FILEDEV1' -targetdevice 'LTO4'
2. To start an interactive object consolidation session for the filesystem object
"system1.company.com:/ 'Label42'" from the session "2008/09/01-2", using
the device "DEV1" to read the source object and the device "DEV2" to
consolidate the object, and write the consolidated object to the device "DEV3",
use:
omniobjconsolidate -filesystem system1.company.com:/
'Label42' -session 2008/09/01-2 -sourcedevice 'DEV1'
-consolidationdevice 'DEV2' -targetdevice 'DEV3'
3. To immediately start a post-backup object consolidation specification named
"post_BU1" for the session "2009/08/03-1", run:
omniobjconsolidate -consolidationlist post_BU1 -postbackup
-session 2009/08/03-1
4. To immediately start a scheduled object consolidation specification named
"Consolidation_16_Spec", run:
omniobjconsolidate -consolidationlist Consolidation_16_Spec
-scheduled
SEE ALSO
omnib(1), omnikeymigrate(1M), omnikeytool(1M), omniobjcopy(1), omniobjverify(1),
omnir(1)
Command line interface reference 177
To Next Page
Loading...
