EasyManua.ls Logo

HP Data Protector A.06.11 - Page 191

HP Data Protector A.06.11
442 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Specifies the original backup object source host as the host on which the object
verification process will be performed.
–verify_on_mahost
Specifies the media agent host as the host on which the object verification process
will be performed.
–verify_on_host hostname
Specifies the host identified by hostname as the host on which the object
verification process will be performed.
-locationpriority MediumLocation [MediumLocation]
The order in which media are selected for object verification if the same object
version exists in more than one location. By default, Data Protector automatically
selects the most appropriate media set. Media location priority is considered if
more than one media set equally match the conditions of the media set selection
algorithm.
The priority must be specified in the form "=MediumLocation" (equal to) or
"<MediumLocation" (lower priority than).
If you specify -locationpriority "=Loc1" "<Loc2" "=Loc3" "<Loc4",
then Loc1 has the highest priority, Loc2 and Loc3 have a lower priority, and
Loc4 has the lowest priority.
-no_monitor
If this option is used, the command displays only the session ID. By default, the
command monitors the session and displays all messages.
-filesystem Client:ObjectName Label
Selects the filesystem identified by Client:ObjectName Label for object
verification.
-winfs Client:ObjectName Label
Selects the Windows filesystem identified by Client:ObjectName Label for
object verification.
-netware Client:ObjectName Label
Selects the Netware filesystem identified by Client:ObjectName Label for
object verification.
-omnidb Client:ObjectName Label
Selects the IDB identified by Client:ObjectName Label for object
verification.
-rawdisk Client:ObjectName Label
Selects the disk image identified by Client: Label for object verification.
ObjectName is blank in this case
Command line interface reference 191

Table of Contents

Other manuals for HP Data Protector A.06.11

Related product manuals