HP Data Protector A.06.11 - Page 218

TreeName and its TargetStoreName pair must always be fully expanded
subcomponents representing an Exchange store or logs. See also the Exchange
2007 examples. To get a list of available targets on a specific host, run the
command:
vssbar -appsrv:HostName -perfom:browse -all
Potential targets can be identified by the string "RESTOREMODE = 1".
NOTE: You cannot restore only a store without logs to a different location. If you
specify a target store for an original store, you must also specify logs with an
additional -tree TreeName -target_tree TargetStoreName pair.
The option must be specified together with -target_dir.
-exch_RSG LinkedStoreName
Creates a new Recovery Storage Group (RSG) and links it to LinkedStoreName.
This option can be used only once for each -tree option and cannot be specified
together with -target_tree. Only one storage group per session can be
restored with this option due to an Exchange limitation. LinkedStoreName
and its TreeName pair must always be fully expanded subcomponents,
representing an Exchange store or logs. See also the Exchange 2007 examples.
IMPORTANT: If the RSG already exists, it is removed and a new one is created.
Any existing data in it will be lost. NOTE: You cannot restore only a store without
logs to a different location. If you specify a target store for an original store, you
must also specify logs with an additional -tree TreeName -target_tree
TargetStoreName pair.
The option must be specified together with -target_dir.
-target_dir Directory
During an instant recovery session, the replica will be mounted to Directory.
The target directory for one session must always be the same, for example, you
cannot specify one target directory for the store(s) and another one for the logs.
SAP DB/MAXDB RESTORE
-sapdb
Selects the SAP DB/MaxDB object for restore.
-barhost ClientName
Specifies the SAP DB/MaxDB client from which the data was backed up.
-instance InstName
Sets the name of the database instance that was backed up.
-destination ClientName
Specifies the target client for restore. Use this option only when you restore to
some other instance than the one that was backed up.
218