-from_disk
Specify this option to apply the existing archive logs on the SAP DB Server to
SAP DB Server redo logs.
If this option is not specified, the backed up archive logs on backup media are
applied to the redo logs (if trans backup session is restored), or the redo logs
are left intact together with the existing archive logs on the SAP DB Server (if full
or diff backup session is restored).
When a transactional backup session is selected for restore or when it is a part
of the needed restore chain, and the this option is specified at the same time,
the archive logs from Data Protector media are applied to the redo logs.
Thereafter, the archive logs on the SAP DB Server are applied to redo logs.
This option is ignored in case of SAP DB migration, thus allowing only for the
restore of redo logs from the backed up archive logs on backup media (if trans
backup session is restored).
-nochain
This option instructs the command to restore only the selected or last backup
session; the integration does not restore the whole restore chain of full, differential,
and transactional backups.
MICROSOFT SQL SERVER RESTORE
-mssql
Selects the Microsoft SQL Server object, identified with DBName for restore.
-barhost ClientName
Specifies the Microsoft SQL Server client from which the data was backed up.
-destination ClientName
Specifies the target client for restore. Use this option only when you restore to
some other instance than the one that was backed up.
-instance SourceInstanceName
Sets the name of the Microsoft SQL Server instance to be restored. Omnir takes
the (DEFAULT) instance by default.
-destinstance DestinationInstanceName
Specify this option to determine an Microsoft SQL Server instance into which the
data will be restored. Omnir takes the (DEFAULT) instance by default.
-base DBName
Specifies the SQL Server database for restore. The database name is
case–sensitive.
-session SessionID
Specifies the session to be used for restore.
220
To Next Page
Loading...
