HP Data Protector A.06.11

To Next Page

To Previous Page

-host ClientName

Restores all objects of the specified client that were backed up in the specified

session.

-session SessionID

Specifies the session to be used for restore.

ENTERPRISE_VIRTUAL_ARRAY_OPTIONS

-check_config

If this option is set, the current volume group configuration of the volume groups

involved in the instant recovery session is compared with the volume group

configuration during the ZDB-to-disk or ZDB-to-disk+tape session kept in the ZDB

database (EVADB or SMISDB). If the volume group configuration has changed

since the ZDB-to-disk or ZDB-to-disk+tape session, the restore is aborted.

When instant recovery is performed in an MC/ServiceGuard cluster to some

other node than the one that was backed up, the current volume group

configuration on the node to which instant recovery is to be performed is different

from the volume group configuration kept in the ZDB database. In such a case

the ZDB database volume group configuration data is replaced by the current

volume group configuration data on the node to which instant recovery is to be

performed and the session is not aborted.

When performing instant recovery in an MC/ServiceGuard cluster to some other

node than the one that was backed up, select this option.

-force_prp_replica

If this option is selected and if any target volume to be restored is presented to

any system, the SMI-S Agent removes these presentations. If the option is not

selected and a presentation exists, the instant recovery session is aborted.

VIRTUAL_ARRAY_OPTIONS

-keep_version

If this option is set, the replica from which the data was restored is left on the

disk array after the restore is finished.