client_1 failed to connect to client_2
checking connection between client_1 and client_2
all checks completed successfully.
number_of_failed_checks checks failed.
client is not a member of the cell.
client contacted, but is apparently an older version. Hostname
is not checked.
Additional return values of the omnicheck command used to list the Data Protector
patches are:
List of patches found on host client
Patch level Patch description
Number of patches found: number_of_patches
List of patches on host client is not available.
Host client is not a member of this cell.
Host client is unreachable.
NOTES
The omnicheck command can be used only within one Data Protector cell.
EXAMPLES
1. To check DNS connections needed for normal Data Protector operating (the Cell
Manager and every Media Agent in the cell resolves DNS connections to every
Data Protector client in the cell properly and vice versa), run:
omnicheck -dns
2. To check if the client with the hostname backup.system.com resolves DNS
connections to every Data Protector client in the same cell properly and vice
versa and to get all relevant messages, run:
omnicheck -dns -host backup.system.com -verbose
3. To list the patches installed on client with the hostname backup.system.com,
run:
omnicheck -patches -host backup.system.com
Command line interface reference 295
To Next Page
Loading...
