HP Data Protector A.06.11 - Page 418

Retrieves the parameter (specified by the option_name) and its value from one
of Data Protector configuration files and writes it to the standard output, unless
the -local option is specified.
-putopt[ion] [integration instance] option_name [option_value]
Sets the specified parameter (specified by the option_name) and (optionally) its
value to the Data Protector configuration files, unless the -local option is used.
To remove a value of a parameter, specify the option_name, without the
option_value. However, if the option is in a sublist, you must specify an empty
("") option_value to remove a value.
-sublist SublistName
Specifies the sublist in the configuration file in which a parameter is written to
or taken from.
-local FileName
If the -local option is used with the -getconf option, the command output
is written to the file with the filename specified by the -local option. If the
-local option is used with the -getopt option, the parameter and its value
is taken from the file with the filename specified by the -local option. If the
-local option is used with the -putopt option, the parameter and its value
is written to the file with the filename specified by the -local option.
-encode Password
Returns the encoded form of the specified password.
EXAMPLES
The following examples illustrate how the util_cmd command works.
1. To set the Data Protector "OB2OPTS" parameter for the Oracle instance "ICE",
run:
util_cmd -putopt Oracle8 ICE OB2OPTS "-debug 1-200
INSTANCE.txt" -sublist Environment
2. To set the Data Protector "OB2OPTS" parameter for the SAP R/3 instance "ICE",
run the following command on the Data Protector SAP R/3 client:
util_cmd -putopt SAP ICE OB2OPTS '-debug 1-200
INSTANCE.txt' -sublist Environment
3. To set the "BR_TRACE" parameter for the SAP R/3 instance "ICE" to value "10"
in the "Environment" sublist, run the following commands on the Data Protector
SAP R/3 client:
418