HP Data Protector A.06.11

To Next Page

To Previous Page

Net services names for the standby database.

-zdb_method {PROXY | BACKUP_SET}

Configures the Oracle database for ZDB environment and sets the ZDB method

to Oracle proxy-copy or Oracle backup set.

-ctlcp_location BACKUP_CONTROL_FILE_COPY_LOCATION

The location on the source volumes where a copy of the current control file is

made during ZDB to disk. This is optional and if not specified, ob2rman.pl will

copy the copy of the control file from the application system to the backup system

when it is needed. Thus, you do not need to create an additional disk for this

location if you do not need the control file copy on a replica.

If you use a raw logical volume as the

BACKUP_CONTROL_FILE_COPY_LOCATION, the raw logical volume must reside

on a volume group that will be replicated. If there is no such raw logical volume

available, create a new shared disk (volume group) residing on the disk that will

be replicated and configure a raw logical volume on it. If you use a raw logical

volume, in case of an ZDB to disk, you need to ensure enough free space in the

/var/opt/omni/tmp directory on the backup host to hold the copy of the raw

logical volume.

-pfile PARAMETER_FILE

Full name of the PFILE residing on the application system. This is optional and

used if backup method is backup set and the database instance uses PFILE (and

not SPFILE).

NOTES

• On HP OpenVMS, to invoke the Data Protector CLI, run:

$@OMNI$ROOT: [BIN] OMNI$CLI_SETUP.COM

• BACKUP_CONTROL_FILE_COPY_LOCATION:

This parameter is optional and if not specified, ob2rman.pl will copy the copy

of the control file from the application system to the backup system when it is

needed. Thus, you do not need to create an additional disk for this location if

you do not need the control file copy on a replica.