BACKUP_SPECIFICATION_OPTIONS
-select SelectList
Specifies which objects (of those in the backup specification) to back up. The
SelectList is the list of objects to be backed up.
-mode{Full | Incremental[1-9]}
Specifies the Mode for the backup session. Full mode backs up all specified
files. Incremental[1-9] backs up only a subset of the specified files, based
on whether or not the files were modified since the last Full or lower-level
Incremental backup. Default is the Full mode. The level of incremental
backup is based on the level number which is specified. For example, an
incremental level 3 backs up only those files (of the specified files) which were
modified since the last incremental level 2 (or lower) backup. Use incremental
level 1 to back up files that were changed since last full backup only. The
Incremental without level will back up the files that changed since the last
backup only (regardless whether it was full or incremental of any level).
-preview
Checks the backup objects, backup devices and options you selected, without
performing the backup. The check includes: objects due for backup, status of the
backup device, available media, and approximate amount of data which will
be backed up.
-disk_only
A ZDB related option. It instructs Data Protector to perform a ZDB-to-disk session
rather than a ZDB-to-tape or ZDB-to-disk+tape session. With ZDB, if the option
is not specified, a ZDB-to-tape or ZDB-to-disk+tape session is performed.
-crc
Instructs the General Media Agent to write a CRC checksum at the end of every
block on the medium. If this option is used, you can later verify the CRC checksum
on the medium by using the omnimver command.
-no_monitor
By default, the command monitors the session and displays the status of the
session during the session. If this option is used only the SessionKey is displayed
and the command is disconnected from the session.
LIST OPTIONS
–barcmnd Command
Specifies the command that will be used instead of the command specified with
exec option in the backup specification. The command should reside in the
/opt/omni/lbin directory.
-barmode SapMode
Command line interface reference 63
To Next Page
Loading...
Need help?
General