some vsnaps or snapclones of the source volumes already exist in a replica set,
the following happens: with the loose option selected, Data Protector creates
either vsnaps (if vsnaps already exist) or snapclones (if snapclones already exist)
instead of standard snapshots.Note that Data Protector can use only one type
of snapshots in the backup session. In case when some of the original virtual
disks used in the backup session have existing standard snapshots and some of
them existing vsnaps, the backup session will be aborted.
-wait_clonecopy number
This parameter is optional and can be selected only if the -snapshot_type
clone option is selected.
In the case of a ZDB to tape or a ZDB to disk+tape, specify this option if you
want to delay moving data to tape media until the cloning process is completed.
By number, specify the maximum waiting time in minutes. After the specified
number of minutes, the backup to tape will start even if the cloning process is
not finished yet.
With this option, you prevent degradation of the application data access times
during the phase of backup to tape.
-replica_conf{local | combined}
Select the EVA configuration. Specify local to configure a backup specification
for ZDB in Business Copy (BC) EVA environments. Specify combined to configure
a backup specification for ZDB in combined Continuous Access + Business Copy
(CA+BC) EVA environments.
-ca_failover_option{follow_replica_direction |
maintain_replica_location}
This parameter is optional and is available only if the combined replica
configuration is selected. Specify this option to control the replication direction
after a failover.
Select follow_replica_direction to follow the replication direction and
create replicas on the array remote to current source. A failover reverses the
replication direction and the replicas are created on the array that was originally
a source EVA.
Select maintain_replica_location to maintain the replica location and
create replicas on the array remote to home. After a failover, replicas continue
to be created on the destination array that has also become a source EVA.
Note that when -ca_failover_option option is selected,
follow_replica_direction is set as default.
EXCHANGE_OPTIONS
-annotation{MIS | SRS | KMS}
Command line interface reference 93
To Next Page
Loading...
Need help?
General