05.1:YZ
Cause
Solution
CPU Fan is stopped or burnt. Try the following:
●
Switch the Power OFF from the back of the Printer and
disconnect the Power cord. Reconnect the power cord
and power On the Printer.
●
Replace the Power Supply Unit (PSU)
refer
Electronics Module (Main PCA and PSU) on page 298.
●
If the System Error continues, replace the Main PCA
refer Electronics Module (Main PCA and PSU)
on page 298.
06:YZ
Cause
Solution
Main NVM failure - not detected, read/write failed or readback
error.
Try the following:
●
Switch the Power OFF from the back of the Printer and
disconnect the Power cord. Reconnect the power cord
and power On the Printer.
●
If the System Error continues, replace the Formatter
refer Formatter on page 296.
08:YZ
Cause
Solution
Problem with the Front Panel. Try the following:
●
Switch the Power OFF from the back of the Printer and
disconnect the Power cord. Reconnect the power cord
and power On the Printer.
●
Check that the Front Panel interface cable is not
damaged and is correctly connected between the Main
PCA and the Front Panel.
●
Check that the memory module in the Formatter is
installed correctly
●
Check that the connections between the Formatter, the
Formatter and the Formatter are not damaged and are
correctly connected.
●
Check that the Printer has the latest Firmware version. If
not, update the Firmware to the latest version.
●
If the System Error continues, replace the Main PCA
refer Electronics Module (Main PCA and PSU)
on page 298.
●
If the System Error continues, replace the Formatter
refer Formatter on page 296.
●
If the System Error continues, replace the Front Panel
refer Front Panel on page 203.
52 Chapter 2 System Error Codes ENWW
To Next Page
Loading...