Hardware options installation 66
8.
Install the TPM board. Press down on the connector to seat the board.
9. Install the TPM security rivet by pressing the rivet firmly into the system board.
10.
11. Install the air baffle.
12. Install the PCI riser cage (on page 29).
13. Install the full-length expansion board retainer (on page 30) if any full-length expansion boards are
installed.
14. Install the access panel (on page 26).
15. Install the server into the rack ("Installing the server into the rack" on page 36).
16. Power up the server (on page 24, "Powering up and configuring the server" on page 37).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of
system integrity.
To Next Page
Loading...
