Setup 36
10 Power supply bay 2 —
11 Power cord connector Black
12 Power supply bay 1 (populated) —
13 iLO 2 connector —
14 Video connector Blue
15 USB connectors (2) Black
16 Serial connector —
17 Mouse connector Green
18 Keyboard connector Purple
WARNING: To reduce the risk of electric shock, fire, or damage to the equipment, do not plug
telephone or telecommunications connectors into RJ-45 connectors.
3. Connect the power cord to the rear of the server.
4. Install the power cord anchor on the handle of the power supply.
NOTE: Peripheral device cables are removed for clarity.
5. Secure cables to the cable management arm.
IMPORTANT: When using cable management arm components, be sure to leave enough slack
in each of the cables to prevent damage to the cables when the server is extended from the
rack.
To Next Page
Loading...
