c. Lift the tape (1) and the locking arm (2) from the connector on the display panel, and then
disconnect the cable (3) from the panel.
12. To remove an IR camera module:
a. Disconnect the cable from the ZIF connector (1) on the module. Starting on the left side of the
module, use a tool (2) to release the module, and then remove the module (3). The IR camera
module is available as spare part number N96912-001.
b. IR cameras use different black protective tape depending on the panel. When installing a new
IR camera, be sure to add new tape that matches the shape of the tape on the old camera.
13. To remove an FHD camera module:
■
Starting on the left side of the module, use a tool (1) to release the module. Lift the module (2) up,
and then disconnect the cable from the ZIF connector on the module. The FHD camera module
Display assembly
65
To Next Page
Loading...
