is available as spare part number N96913-001. The microphone module is available as spare
part number N99998-001.
NOTE: During installation, note that the cable routes under the camera module before it
connects to the module.
14. To remove the ambient light sensor (ALS):
■
Disconnect the cable from the ZIF connector (1) on the board, and then use a tool (2) to release
the board from the display.
The ambient light sensor is available as spare part number N96911-001.
15. To remove the hinges from the display enclosure:
a. Remove the three Phillips M2.0 × 2.0 screws (1) from each hinge.
b. Remove the cables (2) from the left hinge.
c. Remove the cables (3) from the right hinge.
66
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
