4. Disconnect the display panel cable (1) from the system board.
5. Carefully disconnect the WLAN module antenna cables from the WLAN module (2).
NOTE: Computer models have either one or two WLAN module antenna cables. On models with two
antenna cables, the #1 white WLAN module antenna cable connects to the WLAN module #1 Main terminal.
The #2 black WLAN module antenna cable connects to the WLAN module #1 Aux terminal.
6. Release the display panel cable and the WLAN module antenna cables from the retention clips (3) that are
built into the computer.
7. Remove the seven Phillips M2.5 × 4.9 screws that secure the display assembly to the computer.
8. Swing the display hinges (1) up and back as far as they will go.
9. Open the display assembly (2) as far as it will open.
56
Chapter 5Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
