HP Elite x360 1040 G9 - NFC Module

3. Detach the NFC module cable (3) from the top cover/keyboard. (The NFC module cable is attached to the top
cover/keyboard with double-sided adhesive.)
4. Remove the NFC module cable.
Reverse this procedure to install theNFC module cable.
NFC module
To remove the NFC module, use this procedure and illustration.
Table 5-15
NFC module description and part number
Description Spare part number
NFC module
NOTE: The NFC module spare part kit does not include the NFC module cable. The NFC module cable is
included in the Cable Kit, spare part number N09289-001.
M08706-001
NFC module antenna cable N13697-001
Before removing theNFC module, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 41).
2. Remove the bottom cover (see Bottom cover on page 41).
3. Remove the battery (see Battery on page 43).
4. Remove the NFC module cable (see NFC module cable on page 65).
Remove the NFC module:
1. Release the ZIF connector (1) to which the NFC module antenna cable is connected, and then disconnect the
NFC module antenna cable from the NFC module.
66
Chapter 5Removal and replacement procedures for authorized service provider parts