2. Carefully disconnect the two antenna cables from the module (1).
3. Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WLAN module (3).
NOTE: The #1 white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black
WLAN antenna cable connects to the WLAN module #1 Aux terminal.
4. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on
the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Solid-state drive
41
To Next Page
Loading...
