USB/audio board
Description Spare part number
USB/audio board for HP 755 836619-001
Before removing the USB/audio board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 34).
5. Remove the battery (see Battery on page 39).
6. Remove the following components:
a. Keyboard (see Keyboard on page 50)
b. Hard drive (Hard drive on page 40)
c. Internal base plate (Internal base plate on page 55)
Remove the USB/audio board:
1. Disconnect the cable from the board (1).
2. Remove the 2 Phillips PM2.5×5.0 screws (2) that secure the USB/audio board to the computer.
3. Lift the board o the top cover (3).
Reverse this procedure to install the USB/audio board.
70 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
