17. If you need to remove the display cable, disconnect the cable from the ZIF connector on the hub board
(1), remove the cable from the clips at the bottom of the display back cover (2), and then remove the
cable (3).
The display panel cable is available as spare part number M07203-001.
18. If you need to remove the camera cable, disconnect the cable from the ZIF connector on the hub board
(1), and then peel the cable o the inside of the display back cover to remove it (2).
The camera cable is available in the Cable Kit as spare part number M07101-001.
70 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
