USB/VGA board
Description Spare part number
USB/VGA board L17979-001
Before removing the USB/VGA board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 30).
5. Remove the battery (see Battery on page 33).
6. Remove the following components:
a. Keyboard (see Keyboard on page 43)
b. Hard drive (Hard drive on page 34)
c. Internal base plate (Internal base plate on page 48)
Remove the USB/VGA board:
1. Disconnect the cable from the USB/VGA board ZIF connector (1).
2. Remove the 2 Phillips M2.5×5.0 screws (2) that secure the USB/VGA board to the computer.
3. Lift the board o the top cover (3).
Reverse this procedure to install the USB/VGA board.
60 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
