Drive cage
You must rotate the drive cage to the upright position to access components underneath it.
To rotate the drive cage:
1. Prepare the computer for disassembly (Preparation for disassembly on page 17)
2. Remove the access panel (Access panel on page 18)
3. Remove the front bezel (Front bezel on page 19).
4. Disconnect the power and data cables from the rear of the drives in the drive cage.
5. Lift the rear of the drive cage up (1), and then slide the drive cage back (2). Then lift the drive cage (3)
out of the chassis.
32 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
