6. Connect the power cable (1) and data cable (2) to the rear of the optical drive.
7. Connect the opposite end of the data cable to one of the light-blue SATA connectors on the system
board.
Removing a 3.5-inch hard drive
NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17)
2. Remove the access panel (Access panel on page 18)
3. Disconnect the power cable (1) and data cable (2) from the rear of the hard drive.
Drives 45
To Next Page
Loading...
