Removing bezel blanks
On some models, there may be bezel blanks covering the optical drive bays. You must remove the bezel blank
before installing an optical drive. To remove a bezel blank:
1. Prepare the computer for disassembly (Preparation for disassembly on page 17)
2. Remove the access panel (Access panel on page 18)
3. Remove the front bezel (Front bezel on page 19)
4. To remove a 5.25-inch optical drive bezel blank, press inward on the two tabs on the right side of the
blank (1), and then rotate the blank
o the front bezel (2).
22 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
