Hood lock (solenoid)
The hood lock is secured to the rear of the chassis with two screws.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (Access panel on page 18).
3. Disconnect the cable (1) from the system board connector labeled HLCK.
4. Remove the two screws (2) that secure the lock to the rear of chassis.
5. Lift the hood lock out of the chassis (3).
To install the hood lock, reverse the removal procedure.
Hood lock (solenoid) 55
To Next Page
Loading...
