3. Lower the stand onto the computer and press down until it clicks into place (2).
Removing an easel stand
To remove the stand:
1. Remove all removable media, such as optical discs or USB flash drives, from the computer.
2. Turn off the computer properly through the operating system, then turn off any external devices.
3. Disconnect the AC power cord from the AC outlet and disconnect any external devices.
4. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket,
towel, or other soft cloth to protect the bezel and screen surface from scratches or other damage.
5. Remove the rear port cover, if it is installed. For instructions, see
Removing the rear port cover
on page 27.
6. Press the release latch under the stand (1).
Attaching and removing a stand 21
To Next Page
Loading...
Need help?
General