Removing the cover from the Vertical stand
To remove the Vertical stand cover, use this procedure and illustration.
1. Lift the access cover o the top of the stand (1).
2. Loosen the thumbscrew (2).
3. Disconnect the cables from the inside of the stand (3).
4. Lift the head unit and stand cover assembly o the stand.
Conguring the fanless hub powered serial ports
You can congure the serial ports as standard (unpowered) serial ports or powered serial ports. Some devices
use a powered serial port. If the serial port is congured as a powered port, devices that support a powered
serial interface do not require an external power source.
To congure the powered serial ports:
12 Chapter 2 Hardware setup
To Next Page
Loading...
