HP Engage One Pro - Configuring the software; Enabling Wake-on Touch; Touch screen calibration

3 Conguring the software
You can congure the computer and integrated peripherals and calibrate the touch screen.
Enabling Wake-on Touch
The Wake-on Touch (WOT) feature automatically turns on the computer when you touch the screen. The WOT
setting is available in the F10 Setup Utility.
To enable Wake-on Touch:
1. Turn on or restart the computer.
2. When the power button light turns on, repeatedly press f10 to access the F10 Setup Utility.
NOTE: If you do not press f10 at the appropriate time, you must restart the computer and again
repeatedly press f10 when the power button light turns.
3. Select Advanced, select Built-In Device Options, and then select Wake-on Touch Panel to enable Wake-
on Touch.
4. To apply and save changes, select Main, and then select Save Changes and Exit.
Touch screen calibration for Windows 10 Professional and
Windows 10 IoT Enterprise for Retail
The Windows calibration tool works only in digitizer touch mode. If you install a retail touch utility, it sets the
touch screen to POS mode (mouse mode) by default and does not allow the Windows calibration tool to run.
To calibrate the touch module in Windows 10 Professional and Windows 10 IoT Enterprise for Retail:
1. Open Control Panel. You can type Control Panel in the Search box to access it.
2. In Control Panel, type calibrate in the Search box. Under Tablet PC Settings, tap the Calibrate the
screen for pen or touch input link. In the Tablet PC Settings dialog box, tap the Calibrate button, and
then proceed to step 3.
3. Follow the on-screen instructions to press the target marks on the touch screen. At the end of the
calibration process, the touch module should be aligned with the video, and the touch points will be
accurate.
Conguring optional HP integrated peripheral modules
Use this information to congure peripheral modules.
To congure the integrated USB peripheral, see the HP Point of Sale Conguration Guide (available in English
only). The guide is located with the documentation on your retail computer and at http://www.hp.com/
support. To access the guide on the retail computer, select Start, and then select HP Point of Sale
Information.
NOTE: Check http://www.hp.com/support for updated software or documentation that became available
between the time your product was manufactured and the time it was delivered to you.
Enabling Wake-on Touch 21