Updating the Engage One Pro
Use these sections to update the Engage One Pro.
Downloading HP Firmware Installer
Use these steps to download the rmware installation app.
1. Go to http://www.hp.com/support.
2. Select Software and drivers, and follow the on-screen instructions to nd your docking station.
3. Follow the on-screen instructions to select and download HP Firmware Installer.
4. Complete the installation wizard.
5. Choose to restart now or later. The computer might not work until the next restart. Click Finish.
Installing updates
You can update the Engage One Pro immediately or the next time the computer is shut down.
To install updates:
1. Open Windows Explorer and navigate to where you saved HP Firmware Installer.
2. Double-click HPFirmwareInstaller.exe, and then select OK.
3. Verify that updates are available, select which updates to install, and then select Install.
TIP: You must be connected to the internet for new updates to download to HP Firmware Installer.
4. Select one of the following:
● Shut down now: Installs the update immediately.
NOTE: You might see the display icker and hear some audio clicks, your internet connection
might be intermittent, and your mouse and keyboard could become unresponsive until installation
is complete.
● Close and shut down later: Installs the update the next time you shut down the computer.
The computer turns on automatically after the rmware update is complete.
22 Chapter 3 Conguring the software
To Next Page
Loading...
