7. Connect the USB power cord (1) and network cable (2) to the head unit.
8. Connect the other end of the USB power cord to the fanless hub.
9. Press the slim VESA mount cover onto the bracket until it snaps into place.
Installing the customer-facing display (CFD)
To install the customer-facing display, use this procedure and illustration.
1. Turn o the computer properly through the operating system, and turn o any external devices.
2. Disconnect the power cord.
NOTE: Regardless of the power state, voltage is always present on the system board as long as the
system is plugged into an active AC outlet. You must disconnect the power cord and wait approximately
30 seconds for the power to drain to avoid damage to the internal components of the computer.
3. Remove the cable cover (1).
Installing the customer-facing display (CFD) 17
To Next Page
Loading...
