NOTE: The mounting bracket requires an 80 mm (3 in) hole in the countertop. The thickness of the
countertop must be 10 mm (0.4 in) to 50 mm (2 in).
To mount the Engage One Pro:
1. Route the cables through the routing hole on the top piece of the mounting bracket (1), and connect the
cables to the computer (2). Insert the mounting bracket at the bottom of the stand (3), and then secure
it by tightening the thumbscrew (4).
2. Route the cables through the hole in the mounting surface, and then place the column over the hole.
3. Position the bottom fastener based on the thickness of your mounting surface. One side is for thick
countertops, and one side is for thin countertops.
14 Chapter 2 Hardware setup
To Next Page
Loading...
