10. Release the ZIF connector (10) to which the ngerprint reader board cable is connected, and then
disconnect the ngerprint reader board cable from the system board.
11. Remove the seven Phillips M2.0 × 3.2 screws (1) that secure the system board to the computer.
12. Lift the left side of the system board (2) as far as the power connector cable allows.
13. Disconnect the power connector cable (3) from the system board.
14. Remove the system board (4) by sliding it up and to the left at an angle.
NOTE: When removing the system board, make note of the location of the I/O bracket (5). The I/O bracket
is not available as a spare part component.
Reverse this procedure to install the system board.
System board
45
To Next Page
Loading...
