28
4 Use the Camcorder
4.1 Initial Setting
Before use the camcorder, use smart phone’s Wi-Fi to connect with
the camcorder and open Go Moto Plus
app to synchronize
date/time.
4.2 Recording
Once start the car engine, the camcorder will automatically power on
and start recording.
Recording will automatically stop when the engine is switched off.
Note:
1. Some vehicle power supply would not turn on / off automatically with the car
engine start, if the camcorder cannot automatically power on/off with the car
engine, please manually connect the power supply with the vehicle power, and
then power on, or manually power off the camcorder and then release the
connector with the car power supply.
2. It can be configured to save a video file for every 1, 2 or 3 minutes of recording.
3. All the videos and photos are saved in the memory card, if memory card is full,
loop recording will generally overwrite the oldest video file.
4.3 Emergency Recording
1. If the Collision Detection function is enabled and a collision is
detected, the camcorder will automatically trigger the
emergency recording. The emergency file is created as a new
file and save in Emergency folder, which will be protected to
avoid being overwritten by normal loop recording. The
To Next Page
Loading...
