To Next Page

To Previous Page

Regulatory notices

The printer meets product requirements from regulatory agencies in your country/region.

This section contains the following topics:

●

Regulatory model identication number

●

FCC statement

●

European Union Regulatory Notice

●

Products with external AC Adapters

Regulatory model identication number

For regulatory identication purposes, your product is assigned with a Regulatory Model Number. The

regulatory model number should not be confused with the marketing names or product numbers.

FCC statement

The United States Federal Communications Commission (in 47 CFR 15.105) has specied that the following

notice be brought to the attention of users of this product.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment o and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and the receiver.

● Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

● Consult the dealer or an experienced radio/TV technician for help.

NOTE: If the product has an Ethernet / LAN port with metallic casing then use of a shielded interface cable

is required to comply with the Class B limits of Part 15 of FCC rules.

Modications (part 15.21)

Any changes or modications made to this device that are not expressly approved by HP may void the user’s

authority to operate the equipment.

For further information, contact: Manager of Corporate Product Regulations, HP Inc. 1501 Page Mill Road,

Palo Alto, CA 94304, U.S.A.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

ENWW Regulatory notices 69

Questions and Answers:

Need help?

Do you have a question about the HP Ink Tank 110 series and is the answer not in the manual?

HP Ink Tank 110 series Specifications

General