Installing a hot-plug SAS disk drive
The server blade supports up to two hot-plug SAS drives.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server blade
or the enclosure unless all hard drive and device bays are populated with either a component
or a blank.
IMPORTANT: The disk drive will not seat properly when 180 degrees out of alignment. Check
the orientation before insertion.
NOTE: For a list of supported disk drives for the server blade, see:
http://h18004.www1.hp.com/products/blades/components/c-class-storage.html
1. Remove the hard drive blank.
2. Prepare the hard drive.
3. Slide the drive into the cage until it is fully seated.
Installing additional components 19
To Next Page
Loading...
