Go to cover page
24
ISP CABLE for CPU
Configuration and procedure
ISP ( In System Program) software is provided by Genesis to upgrade
the firmware of CPU.
ISP cable is for the interface between "Parallel port of PC" and
"15 pin-D-SUB connector of monitor.
System and equipment requirements:
1. An i386 (or above ) personal computer or compatible.
2. Microsoft operation system Win 95/98 or Win 2000
3. ISP software
4. ISP cable (3138 106 10148) as shown in Fig.1
Fig.1 ISP CABLE :12NC IS "3138 106 10148".
5.Connect ISP cable and main cord to monitor as shown in Fig.2.
6. Install and setup the Gprobe 4.5.0.5.exe program
step 1. Create a folder in your PC .for example: D:\1940
step 2.Copy ISP software 1940 software .Zip into your folder
step 3.Unzip ISP.ZIP into your folder as shpwn in Fig.3
step 4.Double click the Gprobe4.5.0.5.exe icon to install the
application as shown Fig.4
Fig.3
Fig.4
Step 5 . Click the next till the setup finished. And creat a short cut on the desktop.
HP L1940
To Next Page
Loading...
Need help?
General
