HP laserjet pro m11-m13 - Energy-conservation settings

Energy-conservation settings
●
Introduction
●
Print with EconoMode
●
Set the Sleep/Auto Off After Inactivity setting
●
Delay When Ports Are Active setting
Introduction
The printer includes several economy features to conserve energy and supplies.
Print with EconoMode
This printer has an EconoMode option for printing drafts of documents. Using EconoMode can use less toner.
However, using EconoMode can also reduce print quality.
HP does not recommend the full-time use of EconoMode. If EconoMode is used full-time, the toner supply might
outlast the mechanical parts in the toner cartridge. If print quality begins to degrade and is no longer acceptable,
consider replacing the toner cartridge.
NOTE: If this option is not available in your print driver, you can set it using the HP Embedded Web Server.
1. From the software program, select the Print option.
2. Select the printer, and then click the Properties or Preferences button.
3. Click the Paper/Quality tab.
4. Click the EconoMode option.
Set the Sleep/Auto Off After Inactivity setting
Use the EWS to set the amount of idle time before the printer enters sleep mode.
Complete the following procedure to change the Sleep/Auto Off After Inactivity setting:
1. Open the HP Embedded Web Server (EWS):
Network-connected printers
a. Print a configuration page to determine the IP address or host name.
i. Press and hold the Cancel
button until the Ready light begins blinking.
ii. Release the Cancel
button.
ENWW Energy-conservation settings 39