To Next Page

To Previous Page

Turning on the Monitor

1. Press the power button on the computer to turn it on.

2. Press the power button on the front of the monitor to turn it on.

CAUTION: Burn-in image damage may occur on monitors that display the same static image on

screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen, you

should always activate a screen saver application or turn off the monitor when it is not in use for a

prolonged period of time. Image retention is a condition that may occur on all LCD screens. Monitors

with a “burned-in image” are not covered under the HP warranty.

* A prolonged period of time is 12 consecutive hours of non-use.

NOTE: If pressing the power button has no effect, the Power Button Lockout feature may be enabled.

To disable this feature, press and hold the monitor power button for 10 seconds.

Mounting the Monitor Panel

You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,

or other mounting fixture. Four threaded mounting holes are provided on the monitor back panel to be

used for mounting purposes.

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the

power and signal cables are both disconnected. If the monitor has a connected audio cable, disconnect

it.

1. Disconnect and remove the signal and power cables from the back of the monitor.

2. Lay the monitor face down on a flat surface.

3. Remove the three screws on the back of the monitor that connect the monitor panel to the pedestal

base (1) and slide the pedestal base from the monitor panel (2).

Figure 3-4 Removing the Pedestal Base

8 Chapter 3 Setting Up the Monitor ENWW

Downloaded from ManualMonitor.com Manuals

Questions and Answers:

Need help?

Do you have a question about the HP LE2201w and is the answer not in the manual?

HP LE2201w Specifications

General

3D	No
Pixel pitch	0.282 x 0.282 mm
Aspect ratio	16:10
Display diagonal	22 \
Display resolution	1680 x 1050 pixels
Viewing angle, vertical	160 °
Contrast ratio (dynamic)	-
Contrast ratio (typical)	1000:1
Display brightness (typical)	250 cd/m²
Supported graphics resolutions	720 x 400, 1152 x 870, 1280 x 960, 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1440 x 900 (WXGA+), 1680 x 1050 (WSXGA+), 640 x 480 (VGA), 800 x 600 (SVGA)
Plug and Play	Yes
LED indicators	Power
Tilt angle range	-5 - 25 °
Panel mounting interface	100 x 100 mm
Product color	Black
Country of origin	China
Storage temperature (T-T)	20 - 60 °C
Operating temperature (T-T)	5 - 35 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	20 - 80 %
Package depth	161 mm
Package width	587 mm
Package height	489 mm
Package weight	4700 g
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (off)	1 W
Power consumption (standby)	2 W
Power consumption (typical)	35 W
Sync input impedance	75 Ω
Dimensions (W x D x H) (imperial)	20.28 x 2.36 x 13.58 \
Mean time between failures (MTBF)	30000 h
DVI-D ports quantity	0

Weight and Dimensions