To Next Page

To Previous Page

To set the timer:

1. Press the Menu button on the monitor front panel to display the OSD Menu.

2. Scroll down and highlight Management.

3. Press the Menu button to select Management.

4. Scroll down and highlight and select Sleep Timer > Set Current Time.

NOTE: You must set the current local time before you reset the time for Sleep Time or On

Time. Note that the time is displayed in a 24–hour clock format. For example, 1:15 p.m. is displayed

as 13 hours 15 minutes.

A power failure or loss of power to the monitor will cause the timer to reset to 00:00. If this occurs,

you will need to reset the sleep timer mode.

5. Press the Menu button once to enter the adjustment mode for hours.

6. Press the - (Minus) or + (Plus) button to adjust the hour.

7. Press the Menu button again to enter the time for minutes.

8. Press the - (Minus) or + (Plus) button to adjust the minutes.

9. Press the Menu button to lock in the time chosen.

10. After setting the current time, the highlight automatically skips to Set Sleep Time hours. Repeat

steps 6 through 9 to set Sleep Time.

11. If you do not want to set Sleep Time, press the Menu button twice, then select Save and

Return to exit the menu.

12. After setting Sleep Time, the highlight automatically skips to Set On Time hours. Repeat steps 6

through 9 to set On Time.

13. Set the Timer mode to On to activate the Sleep Timer settings.

14. When you are finished, select Save and Return to exit the menu.

The fifth selection, Sleep Now, turns the monitor backlights off immediately and stays in sleep mode

until the next On Time activates or a monitor button is pressed.

22 Chapter 4 Operating the Monitor ENWW

Downloaded from ManualMonitor.com Manuals

Questions and Answers:

Need help?

Do you have a question about the HP LE2201w and is the answer not in the manual?

HP LE2201w Specifications

General

3D	No
Pixel pitch	0.282 x 0.282 mm
Aspect ratio	16:10
Display diagonal	22 \
Display resolution	1680 x 1050 pixels
Viewing angle, vertical	160 °
Contrast ratio (dynamic)	-
Contrast ratio (typical)	1000:1
Display brightness (typical)	250 cd/m²
Supported graphics resolutions	720 x 400, 1152 x 870, 1280 x 960, 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1440 x 900 (WXGA+), 1680 x 1050 (WSXGA+), 640 x 480 (VGA), 800 x 600 (SVGA)
Plug and Play	Yes
LED indicators	Power
Tilt angle range	-5 - 25 °
Panel mounting interface	100 x 100 mm
Product color	Black
Country of origin	China
Storage temperature (T-T)	20 - 60 °C
Operating temperature (T-T)	5 - 35 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	20 - 80 %
Package depth	161 mm
Package width	587 mm
Package height	489 mm
Package weight	4700 g
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (off)	1 W
Power consumption (standby)	2 W
Power consumption (typical)	35 W
Sync input impedance	75 Ω
Dimensions (W x D x H) (imperial)	20.28 x 2.36 x 13.58 \
Mean time between failures (MTBF)	30000 h
DVI-D ports quantity	0

Weight and Dimensions