To Next Page

To Previous Page

1. Remove the four screws from the VESA holes located on the rear of the monitor head.

2. To attach the monitor head to a swing arm or other mounting device, insert four mounting screws

through the holes on the mounting device and into the VESA screw holes on the back of the monitor

head.

IMPORTANT: If these instructions do not apply to your device, then follow the mounting device

manufacturer’s instructions when mounting the monitor to a wall or swing arm.

Connecting the cables

In addition to details about how to connect a cable, this section contains information about how your monitor

functions when you connect certain cables.

NOTE: Depending on the model, the monitor might be capable of supporting USB Type-C, HDMI, or

DisplayPort inputs. The video mode is determined by the video cable used. The monitor automatically

determines which inputs have valid video signals. You can select the inputs through the OSD menu. The

monitor ships with select cables. Not all cables shown in this section are included with the monitor.

1. Place the monitor in a convenient, well-ventilated location near the computer.

Connecting the cables

Other manuals for HP M34D

Questions and Answers:

Need help?

Do you have a question about the HP M34D and is the answer not in the manual?

General