Hardware options installation 24
13.
Secure the media bay screws.
14. Close the media bay retainers.
Installing a half-height media device
NOTE: This process only represents one installation method. For specific instructions for installing the media
device into the server, refer to the installation sheet for your specific server.
1. Power down the server (on page 6).
2. Extend the server from the rack, if applicable.
3. Remove the access panel ("Access panel" on page 6).
4. Access the removable media cage.
5. Remove the bezel blank.
NOTE: HP recommends that you remove all bezel blanks to facilitate drive installation.
6. Release the media bay retainers and slide the half-height media device part of the way into the bay.
To Next Page
Loading...
