MSM410
Initial configuration (autonomous mode)
2-11
Note To avoid a delay after switching modes, clear the ARP (address resolution protocol) cache on
your computer. In Windows for example, from the Windows Start menu, select Run and
enter “arp -d” (without the quotes). Select OK.
Step 4: Log in
1. Wait until the Power light stops blinking and remains on.
2. On the Login page, specify admin for both Username and Password, and then select
Login.
3. On the License Agreement page, read the agreement and select Accept License
Agreement.
4. On the Registration page, register now if desired. You can register later by selecting
Maintenance > Registration.
5. If a Country prompt appears, select the country in which the MSM422 will operate. The
correct country must be selected. See Country of use on page 2-6.
6. At the password prompt it is recommended that you change the default password and
select Save. Passwords must be at least six characters long and include four different
characters.
The management tool is organized with menus and sub-menus. Instructions for making menu
selections, such as “select Wireless > Local mesh” instruct you to select the Wireless menu
and then the Local mesh sub-menu, as follows:
Step 5: Assign an IP address to the MSM410
By default the MSM410 operates as a DHCP client. This means that if the network has a
DHCP server, the MSM410 will automatically receive a new IP address in place of its default
address of 192.168.1.1 upon connecting to the network. Use one of the following methods to
assign an IP address to the MSM410:
Pre-configure the DHCP server to assign a specific IP address to the MSM410. To do
this you need to specify the MSM410 Ethernet MAC address and a reserved IP address on
the DHCP server. The MSM410 Ethernet MAC address is printed on the MSM410 label
identified as Ethernet Base MAC, and listed on the management tool Home page as
Ethernet base MAC address.
Let the DHCP server automatically assign an IP address. By default, the DHCP
server will assign an IP address once the MSM410 connects to the network. Once the
DHCP server has assigned the MSM410 an IP address, you can then find the IP address of
the MSM410 by looking for its Ethernet base MAC address in the DHCP server log. For
To Next Page
Loading...
Need help?
General
