4. On the Guest DHCP addressing page, select DHCP server.
a. Define the DHCP server IP address range:
• Set Start address to 192.168.1.1
• Set End address to 192.168.1.254
• Set Netmask to 255.255.255.0
NOTE: The first address in the range is reserved for the controller gateway and DNS
(192.168.1.1 in this example). The DHCP server assigns addresses to clients at Start
address +1, (192.168.1.2 in this example).
b. Select Next.
5. On the Apply guest access settings to your APs page, select Next to accept the defaults.
6. The last page in the workflow lists all configuration settings that will be applied.
20 Controller initial configuration
To Next Page
Loading...
