Solid state drive
Description Spare part number
512 GB 847110-020
256 GB 847109-023
128 GB 912322-006
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement
Before removing the solid state drive, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 33).
Remove the solid state drive:
1. Remove the Phillips screw (1).
2. Remove the solid state drive at an angle (2).
Reverse this procedure to install the solid state drive.
Component replacement procedures 37