Display cable and webcam cable
NOTE: The display cable and webcam cable are spared together in a kit.
Description Spare part number
Display and webcam cable for use only on models equipped with an ultra high denition (UHD) panel and
infrared webcam
929454-001
Display and webcam cable for use only on models equipped with an ultra high denition (UHD) panel and
standard webcam
929453-001
Display and webcam cable for use only on models equipped with an full high denition (FHD) panel and
infrared webcam
929452-001
Display and webcam cable for use only on models equipped with an full high denition (FHD) panel and
standard webcam
929451-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement
Before removing the display cable and webcam cable, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 33), and then remove the following components:
a. Hinge covers (see Hinge covers on page 48).
b. System support brackets (see System support brackets on page 49).
c. Heat sink (see Heat sink on page 56).
d. System board (see System board on page 61).
e. Display assembly (see Display assembly on page 65).
f. Display bezel (see Display bezel on page 70).
g. Display panel (see Display panel on page 76).
Remove the display cable and webcam cable:
1. Release the webcam cable from the clips securing it to the back cover (1).
Component replacement procedures 79