HP P2000 G3 MSA User Manual

12 Event descriptions
19
Info. A rescan has completed.
Recommended actions
• No action is required.
20
Info. Storage Controller firmware update has completed.
Recommended actions
• No action is required.
21
Error Vdisk verification completed. Errors were found but not corrected.
Recommended actions
• Perform a vdisk scrub to find and correct the errors.
Warning Vdisk verification did not complete because of an internally detected condition such as a failed disk.
If a disk fails, data may be at risk.
Recommended actions
• Resolve any non-disk hardware problems, such as a cooling problem or a faulty controller module,
expansion module, or power supply.
• Check whether any disks in the vdisk have logged SMART events or unrecoverable read errors.
• If so, and the vdisk is a non-redundant RAID level (RAID 0 or non-RAID), copy the data to a different
vdisk and replace the faulty disks.
• If so, and the vdisk is a redundant RAID level, replace the faulty disks. Before replacing a disk,
confirm that a reconstruction is not currently running on the vdisk. It is also recommended to make a
full backup of all the data on the vdisk before replacing disks. If more than one disk in the vdisk has
errors, replace the disks one at a time and allow reconstruction to complete after each disk is
replaced.
Info. Vdisk verification failed immediately, was aborted by a user, or succeeded.
Recommended actions
• No action is required.
23
Info. Vdisk creation has started.
Recommended actions
• No action is required.
25
Info. The statistics for the indicated vdisk have been reset.
Recommended actions
• No action is required.
27
Info. Cache parameters have been changed for the indicated vdisk.
Recommended actions
• No action is required.

HP P2000 G3 MSA Specifications

General

Model	HP P2000 G3 MSA
Form Factor	2U
Drive Types	SAS, SATA
Controllers	Dual controllers
Host Interface	SAS, iSCSI, Fibre Channel
RAID Levels	0, 1, 5, 6, 10
Management	Web-based, CLI
Cache Memory	2 GB per controller